10 pastel Easter egg lights
have 12 inch spacing between the Easter eggs. The Easter decorations white wires are 13 feet long. It is 4 feet from the white plug to the first Easter egg. The white electrical plug is stackable and allows two additional Easter lights to be added on to the Easter egg lights. The Easter eggs decorations have two each of yellow, blue, pink, crystal and green egg covers.
For indoor use only.
United States UL approved for 110 volt.
2,000 hour 12 volt super bright bulbs.
12 inch spacing between the light bulbs.
When one light bulb burns out the others remain lighted.
This Easter egg lights set has a stackable electrical plug that allows two additional Easter party light sets to be added on.
Up to three like Easter Egg lights can be connected together.
This Easter light set can be made to steady flash on and off by replacing the first steady burning bulb with a clear red tipped Easter light bulb.
Replacement light bulbs, flasher light bulbs, and 3 amp. 125 volt fuses are included.
Complete use and care instructions for the holiday light bulbs is also included. Easter egg light bulbs safety instructions:
When using Easter lights, basic precautions should always be followed including these holiday light safety tips.
These lights are suitable for indoor and outdoor use. When Easter decorations are used in outdoor applications, connect the outdoor Easter lights to a ground fault circuit interrupting [GFCI] electrical outlets. If one is not provided, contact a qualified electrician for proper outdoor lights installation.
Seasonal party lights are not intended for permanent installation or use.(90 Days Max)
Do not mount or place christmas lights near gas or electric heaters, fireplaces, candles or other similar sources of heat.
Do not secure the light sets with staples or nails, or place on sharp hooks.
Do not let the light bulbs rest on the supply cord or on any wire.
Unplug the light strands when leaving the house, when retiring for the night, or if the lights are left unattended.
Your Easter holiday lights are not toys! To avoid risk of fire, burns, personal injury and electric shock the lights should not be played with or placed where small children can reach the light bulbs.
To reduce the risk of fire or electrical shock do not mount or support the lights in a manner that can cut or damage the spring light sets.
Do not close your doors or windows on the lights or extension cords as this may cut and damage the wire insulation.
Do not cover the light bulbs or lights with cloth, paper or any material not part of the lights when in use.
The Easter lights are equipped with push-in type light bulbs, do not twist the light bulbs. Pull the bulbs straight out of the light bulb socket.
To reduce the risk of overheating, replace any burned out light bulbs promptly. Use the proper light bulbs with like volt and wattage replacement light bulbs.
Always unplug your lights before installing or replacing the light bulbs.
Do not overload the electrical wiring of the light strands. Only connect the recommended amount of light sets [usually three sets if not stated in instructions] on one connector plug.
Easter egg lights with overload fuses.
A blown fuse indicates an overloaded circuit and you need to reduce the amount of lights connected to the circuit. A blown fuse may also be caused by a short-circuit and the light set with the short-circuit should be discarded.
1.) Always unplug your holiday lights before installing or replacing the light fuses.
2.) Slide open the holiday light fuse access cover on top of the attachment plug towards the plug in metal blades.
3.) Remove the fuses carefully.
4.) To avoid the risk of fire replace the blown fuses with like amp and volt fuses that were provided with the lights.
5.) Slide closed the fuse access cover by sliding the cover closed so that all fuse tabs latch.
6.) To avoid the risk of fire do not replace the factory light plug. The factory holiday light plug contains a safety device (fuse) that should not be removes. Discard the party light set if the plug is damaged.
