35 Easter light bulb set
with multi pastel bulbs and white wire cords. These premium Quality light bulbs sets are 14 Feet long. The pastel bulb colors are pink, blue, green, gold and peach.
These lights are for indoor and outdoor use.
United States UL approved for 110 volt.
4 inch spacing between the light bulbs.
When one light bulb burns out the others remain lighted.
Easter tree light strand uses only 20 watts of energy.
This light bulb set has a plug at one end and an end connector on the other end for additional light bulb sets.
Up to six additional like light bulb sets can be added.
This pastel light set can be made to flash on and off by replacing the first steady burning bulb with a clear red tipped light bulb.
Replacement light bulbs, flasher light bulbs, and fuses are included.
Complete use and care instructions for the holiday light bulbs are also included.
light bulbs safety instructions:
When using Easter tree lights, basic precautions should always be followed including these light safety tips.
When these lights are used in outdoor applications, connect the outdoor lights to a ground fault circuit interrupting [GFCI] electrical outlets. If one is not provided, contact a qualified electrician for proper outdoor lights installation.
Seasonal party lights are not intended for permanent installation or use.
Do not mount or place these lights near gas or electric heaters, fireplaces, candles or other similar sources of heat.
Do not secure the light sets with staples or nails, or place on sharp hooks.
Do not let the light bulbs rest on the lights supply cord or on any wire.
Unplug the light bulbs when leaving the house, when retiring for the night, or if the Easter tree lights are left unattended.
These lights are not toys! To avoid risk of fire, burns, personal injury and electric shock the lights should not be played with or placed where small children can reach the light bulbs.
To reduce the risk of fire or electrical shock do not mount or support the lights in a manner that can cut or damage the light sets.
Do not close your doors or windows on the lights or extension cords as this may damage the wire insulation.
Do not cover the light bulbs or party lights with cloth, paper or any material not part of the light when in use.
If your lights are equipped with push-in type light bulbs, do not twist the light bulbs. Pull the party light bulbs straight out of the light bulb socket.
To reduce the risk of overheating, replace any burned out light bulbs promptly. Use the proper light bulbs with like volt and wattage replacement light bulbs.
Always unplug your lights before installing or replacing the light bulbs.
Do not overload the electrical wiring of the lights. Only connect the recommended amount of light sets [usually three sets if not stated in instructions] on one continuous light string.
Lights with overload fuses.
A blown fuse indicates an overloaded circuit and you need to reduce the amount of lights connected to the circuit. A blown fuse may also be caused by a short-circuit and the light set with the short-circuit should be discarded.
1.) Always unplug your lights before installing or replacing the christmas light fuses.
2.) Slide open the light fuse access cover on top of the attachment plug towards the plug in metal blades.
3.) Remove the fuses carefully.
4.) To avoid the risk of fire replace the blown fuses with like amp and volt fuses that were provided with the christmas lights.
5.) Slide closed the light fuse access cover by sliding the cover closed so that all fuse tabs latch.
6.) To avoid the risk of fire do not replace the factory light plug. The factory light plug contains a safety device (fuse) that should not be removes. Discard the party light set if the plug is damaged.
