Rudolph bubble light night-light comes with a swivel plug to fit any outlet. The Rudolph bubble light night light is seven inches tall. The Rudolph figure is 2 inches tall and has a wire holder that fits over the bubble light. The Rudolph bubble night-light has clear liquid in the bubbling part. The switch for the Rudolph bubble light night light is located on the front for easy on/off action. Rudolph the Red-Nosed Reindeer helps light the way for Santa, so why can't Rudolph help brighten a room in your house. His shining red nose and the bubbling liquid in the bubble nightlight will be enjoyed by young and old.
Tip; What to do when the bubble lights bulb tubes ceases to bubble. Unplug the Rudolph bubble lights from the wall outlet. Unscrew the bubble lights from the light socket and give the Rudolph bubble light bulb a good shaking. When shaking the bubble lights, the liquids will be mixed together again, restoring the Rudolph bubble lights to their original bubble light action.
Christmas holiday light bulbs safety instructions:
When using Rudolph bubble night lights, basic precautions should always be followed including these Rudolph bubble light safety tips.
the Rudolph tree lights are left unattended.
burns, personal injury and electric shock the Rudolph bubble lights should not be played
with or placed where small children can reach the bubble light bulbs.
or bubble lights in a manner that can cut or damage the bubble light sets.
this may damage the wire insulation.
not part of the holiday light when in use.
sure that you do not over tighten the bubble light bulbs causing the protective glass covering
to break or crack.
amount of Rudolph bubble light sets [usually six sets if not stated in instructions] on one
continues light string.
Rudolph bubble lights with overload fuses.
A blown fuse indicates an overloaded circuit and you need to reduce the amount of bubble
lights connected to the circuit. A blown fuse may also be caused by a short-circuit and the
Rudolph bubble light set with the short-circuit should be discarded.
1.) Always unplug your Rudolph bubble lights before installing or replacing the Rudolph light fuses.
2.) Slide open the bubble light fuse access cover on top of the attachment plug towards the
plug in metal blades.
3.) Remove the bubble light fuses carefully.
4.) To avoid the risk of fire replace the blown fuses with like amp and volt fuses that were
provided with the Rudolph bubble lights.
5.) Slide closed the bubble light fuse access cover by sliding the cover closed so that all fuse tabs latch.
6.) To avoid the risk of fire do not replace the factory Rudolph bubble light plug. The factory
bubble light plug contains a safety device (fuse) that should not be removes. Discard the
bubble lights set if the plug is damaged.