Stanley Double Flood Light Outdoor Stake

The Stanley Double Flood Light Outdoor Stake
is for outdoor use. The Power Strips and Power Protection Supplies environmentally safe electrical flood light ground stake has a total cord length of 10 ft. The 2 individual lamp holders are spaced 6 feet apart with a 4 foot lead wire. You can adjust the flood lamp holders to different angles and turn the light base 360 degrees so you can put the light where you need it. Flexible rubber ends make a water tight seal against the flood lamp bulbs. The 6.5 inch ground stake allows for more versatility in placement of the Stanley double flood light holder. The ground stakes screw into the base of each flood light holder. Instructions for the Outdoor Christmas Decorations outdoor flood light stake are included. High impact fixture resists weather and wear. Do not lean against an object, use the ground stake at all times. Use a foot rest when inserting the stake into the ground. Select to see a complete listing of our Christmas Decorations Ideas.

Do Not unscrew the wing nut fully. Doing so will make the screw come undone from the securing wing nut. Twist the knob 2 turns maximum to adjust the angle of the flood lamp holder.

The Stanley name is recognized as a quality home product and is the registered trademark of Stanley Works and Subsidiaries. This Stanley quality product is made to insure a safe and memorable holiday season.

Christmas Light Stake Safety Instructions:

Do not use the flood lamp stake unless is marked suitable for outdoor use. Connect the Christmas Outdoor Lights to a ground fault circuit interrupting [GFCI] electrical outlets. If one is not provided, contact a qualified electrician for proper outdoor installation.

Do not install or mount the flood light stake near gas or electric heaters, fireplaces, candles or other similar sources of heat.

Make sure all connections are dry before inserting the flood light into the holder.

Do not let the replacement photocell flood light bulbs rest on the holiday lights supply cord or on any wire.

Do not cover the flood light bulbs with cloth, paper or any material not part of the replacement bulb when in use.

The flood lamp holder is equipped for threaded screw flood lights. Make sure that you do not over tighten the bulbs causing the protective glass covering to break or crack.

Always turn off your power to the flood light holder before installing or replacing the replacement bulbs.

Do not overload the electrical wiring and socket that you are using the flood lamp bulb holder for. Select this link to read the Safety and Care Instructions for Christmas lights.