35 Clear Christmas light bulb set.
Premium Quality Christmas light bulb set. The Christmas light bulb set is 25 feet long.
Christmas lights are for indoor and outdoor use.
United States UL approved for 110 volt.
2,000 Hour Super Bright Christmas light bulbs.
8 inch spacing between the Christmas light bulbs.
When one Christmas light bulb burns out the others remain lighted.
Christmas tree light strand uses only 24 watts of energy.
This holiday light set can be made to flash on and off by replacing the first steady burning bulb with a clear red tipped Christmas tree light bulb.
Replacement light bulbs, flasher light bulbs, and fuses are included.
Complete use and care instructions for the holiday light bulbs are also included.
light bulbs safety instructions:
When using Christmas tree lights, basic precautions should always be followed including these christmas holiday light safety tips.
When these lights are used in outdoor applications, connect the outdoor christmas lights to a ground fault circuit interrupting [GFCI] electrical outlets. If one is not provided, contact a qualified electrician for proper outdoor lights installation.
Seasonal lights are not intended for permanent installation or use.
Do not mount or place these lights near gas or electric heaters, fireplaces, candles or other similar sources of heat.
Do not secure the light sets with staples or nails, or place on sharp hooks.
Do not let the light bulbs rest on the supply cord or on any wire.
Unplug the christmas lights when leaving the house, when retiring for the night, or if the christmas tree lights are left unattended.
These lights are not toys! To avoid risk of fire, burns, personal injury and electric shock the lights should not be played with or placed where small children can reach the light bulbs.
To reduce the risk of fire or electrical shock do not mount or support the light set in a manner that can cut or damage the holiday light sets.
Do not close your doors or windows on the lights or extension cords as this may damage the wire insulation.
Do not cover the light bulbs lights with cloth, paper or any material not part of the light when in use.
If your lights are equipped with push-in type light bulbs, do not twist the light bulbs. Pull the light bulbs straight out of the light bulb socket.
To reduce the risk of overheating, replace any burned out light bulbs promptly. Use the proper light bulbs with like volt and wattage replacement light bulbs.
Always unplug your lights before installing or replacing the light bulbs.
Do not overload the electrical wiring of the lights. Only connect the recommended amount of seasonal light sets [usually three sets if not stated in instructions] on one continuous light string.
Lights with overload fuses.
A blown fuse indicates an overloaded circuit and you need to reduce the amount of lights connected to the circuit. A blown fuse may also be caused by a short-circuit and the light set with the short-circuit should be discarded.
1.) Always unplug your lights before installing or replacing the light fuses.
2.) Slide open the light fuse access cover on top of the attachment plug towards the plug in metal blades.
3.) Remove the fuses carefully.
4.) To avoid the risk of fire replace the blown fuses with like amp and volt fuses that were provided with the christmas lights.
5.) Slide closed the light fuse access cover by sliding the cover closed so that all fuse tabs latch.
6.) To avoid the risk of fire do not replace the factory christmas light plug. The factory light plug contains a safety device (fuse) that should not be removes. Discard the light set if the plug is damaged.
