Set of 7 multi colored Christmas bubble lights with 20 inch spacing between the bubble lights. The overall length of the bubble light set is 11.6 feet. The bubble lights have end to end connectors which allows you to add up to 6 bubble light sets together. These nostalgic Christmas bubble lights are for a 120 volt lines.
Tip; What to do when the bubble lights bulb tubes ceases to bubble. Unplug the
Christmas bubble lights from the wall outlet. Unscrew the bubble lights from the light socket
and give the Christmas bubble light bulb a good shaking. When shaking the bubble lights
the liquids will be mix together again, restoring the Christmas bubble lights bubbles to their
original bubble light action.
Christmas holiday light bulbs safety instructions:
When using Christmas tree bubble lights, basic precautions should always be followed including
these christmas bubble light safety tips.
will start.
vial breaks, open the windows and ventilate the room. Do Not breath the fumees and keep
the bubble lights out of the reach of children.
for indoor and outdoor use. When outdoor christmas bubble lights are used in outdoor applications,
connect the outdoor christmas lights to a ground fault circuit interrupting [GFCI] electrical
outlets. If one is not provided, contact a qualified electrician for proper outdoor lights installation.
other similar sources of heat.
the christmas tree lights are left unattended.
burns, personal injury and electric shock the christmas bubble lights should not be played
with or placed where small children can reach the bubble light bulbs.
or bubble lights in a manner that can cut or damage the bubble light sets.
this may damage the wire insulation.
not part of the holiday light when in use.
sure that you do not over tighten the bubble light bulbs causing the protective glass covering
to break or crack.
amount of christmas bubble light sets [usually six sets if not stated in instructions] on one
continues light string.
Christmas bubble lights with overload fuses.
A blown fuse indicates an overloaded circuit and you need to reduce the amount of bubble
lights connected to the circuit. A blown fuse may also be caused by a short-circuit and the
christmas bubble light set with the short-circuit should be discarded.
1.) Always unplug your christmas bubble lights before installing or replacing the christmas light fuses.
2.) Slide open the bubble light fuse access cover on top of the attachment plug towards the
plug in metal blades.
3.) Remove the bubble light fuses carefully.
4.) To avoid the risk of fire replace the blown fuses with like amp and volt fuses that were
provided with the christmas bubble lights.
5.) Slide closed the bubble light fuse access cover by sliding the cover closed so that all fuse tabs latch.
6.) To avoid the risk of fire do not replace the factory christmas bubble light plug. The factory
bubble light plug contains a safety device (fuse) that should not be removes. Discard the
bubble lights set if the plug is damaged.